SB DDC35-001 
New software for the Hi-35PC Print Controller (Version 1.18 replaces version
1.16)) and new printer drivers comprise the changes providing support
for Windows 2000 Server.
SB DDC35-002
The paper take-up section has been modified to improve performance and
prevent multiple paper feeding when paper with a high friction resistance
is used in the AFR-14 (Duplexing Document Feeder).
SB DDS Scanner-01
New software adding support for the DDS50/62
printer's ScanCenter option is now available. The software is provided
through a new ScanCenter Option Kit (able to be connected to either DDS32/40
or to DDS50/62).
SB DDC52/62-001
To improve
the document separating performance of the EDH-1, a new Separator Pad
and two Tension Springs have been made available.
SB DDC52/62-002
To
ensure that Spare PWB-B boards will power on and display messages in English
(instead of Japanese)
SB DDC52/62-003
This bulletin
provides information on the original EPROM configurations and the most
current EPROMS that are in production as pertains to both the DDC52/62
(Copier only) models and the DDC52N/62N (Networkable printer/copier) models.
SB DDC52/62-004
A problem
related to certain "lot numbers" of the PWB-Y (RAM Pack) has
been recently reported.
SB DDC52/62-005
Due to a problem noted on the copier production line with certain lots
of Solid State Switch (also known as photo interrupter) used in many parts
of the machine, condensers were added to the PWB-A.
SB
DDC52/62-006 The
Stapler Unit (P/N 4470-4351-04) as shown on Figure 20 (Item 11) of the
Finisher Illustrated Parts List
has no serviceable parts identified.
SB
DDC52/62-007 The
Punch Unit (P/N 4470-0153-12 for USA and P/N 4470-0155-01 for Europe) as
shown on Figure 15 (Item 03)
of the Finisher Illustrated Parts List has no serviceable parts identified.
SB
DDC52/62-008 The
design change has added reinforcement plates to the descending/ascending
grooves of the Elevator Tray on the
front and rear frames of the finisher. In addition the teeth on the gears
in the Elevator Tray driving section have
been widened, reinforcement plates have been added (front/rear axle plates),
and software changes have been made
to the IC (ROM) used on the Finisher's PWB-A.